Let's Build a Can Stirling Engine

Step 4 - Make a Diaphragm


To Japanese Page


You will make a diaphragm using a rubber balloon. As shown in the following figure, cut the balloon and reinforce it by pasting the card boards. Make a hole in the center of the diaphragm and pass through a fishing thread. Be careful to make a close-fitting hole - not a big hole.

Make a Diaphgram


Go to Before Page --- Go to Next Page

Return to 'Let's Build a Can Stirling Engine'

Return To 'Let's Build Model Stirling Engines'

Go to Stirling Engine Home Page

Koichi Hirata