Let's Build a Can Stirling Engine

Step 5 - Make Connecting Rods and a Crank Shaft


To Japanese Page


As illustrated in the following figure, make two connecting rods using lumber that is 5 mm square. Make the holes for the crank shaft somewhat bigger to reduce friction. Bend a wire of1.5 mm. diameter. Put on the connecting rods before bending the wire.

Connecting Rods and Crank Shaft


Go to Before Page --- Go to Next Page

Return to 'Let's Build a Can Stirling Engine'

Return To 'Let's Build Model Stirling Engines'

Go to Stirling Engine Home Page

Koichi Hirata